Available for purchase separately, VersaClip™ makes installation easy, as it simply slides on the ColorGard® crossmember. It can be used with all S-5!™ clamps (one per clamp), and is optional with CorruBracket™. VersaClip™ is not needed with VersaBracket™. VersaClip™ is also handy when installing ColorGard® askew, such as is required in the valleys between intersecting rooflines. ...

>Unpunched ColorGard is the most versatile and easy to install, when used with the S-5! VersaClip. Unpunched does not need holes, as the VersaClip accommodates any seam spacing. The unpunched configuration works well with VersaBracket.  Unpunched is the right choice when the roof is laid out with untrue seam width or when the seam width is not divisible by 4. If in doubt, use unpunched. Included with crossmembers, use the Splice to join two pieces of ColorGard together, ensuring...

Punched ColorGard® is slotted every 4” (10.2 cm) on center for seams that are spaced accordingly, i.e. divisible by 4” (10.2cm). The slotted configuration works well with S-5!™ clamps.  

SnoClip™ is an aluminum add-on that helps retard the migration of snow and ice beneath either the ColorGard® crossmember, or the SnoRod™ of a SnoRail™ or SnoFence™ system. It has a special integrated rubber "foot" to prevent abrasion of the panel's finish. SnoClip™ snaps to the back of the crossmember or rod and extends down to the flat of the roofing panel.

SnoClip™ is an aluminum add-on that helps retard the migration of snow and ice beneath either the ColorGard® crossmember, or the SnoRod™ of a SnoRail™ or SnoFence™ system. It has a special integrated rubber "foot" to prevent abrasion of the panel's finish. SnoClip™ snaps to the back of the crossmember or rod and extends down to the flat of the roofing panel.

An important component in S-5! ColorGard snow retention systems, the SnapClip is designed to prevent ice that forms on the metal panel's surface from sliding under the ColorGard assembly. Usually only required on the bottom row of ColorGard, the SnapClip features a rubber foot that prevents scratching or damage to the roof panels surface. The SnapClip is designed to be "snapped" onto the ColorGard cross-member after installation, therefore can be retrofit on in-place systems. One (1) SnapClip...

An important component in ColorGard snow retention systems, the SnapClip is designed to prevent ice that forms on the metal panel's surface from sliding under the ColorGard assembly. Usually only required on the bottom row of ColorGard, the Snap-Clip features a rubber foot that prevents scratching or damage to the roof panels surface. The SnapClip is designed to be "snapped" onto the ColorGard cross-member after installation, therefore can be retrofit on in-place systems. One (1) SnapClip is...

The S-5-R clamp was specifically designed for those profiles manufactured by Rib Roof® and roofing types with similar profiles. It can be installed with or without a supplemental sheet metal screw, providing truly unsurpassed holding power. When using the S-5-R for snow retention, the assembly should be specifically engineered to each individual project for maximum protection. The S-5-R clamps is furnished with the hardware shown above. A structural aluminum attachment clamp, the S-5-R is...