Price: $20.55
Item #204-SQ601BA
Write a review!
Quantity:
Description
This standard roof flashing's flexible design meets virtually all roofing needs. Made of EPDM, the flashings are compounded specifically for maximum resistance to weathering due to ozone and ultraviolet light. Easy on-site customization allows for easy installation in usually five minutes, and the flexible soft aluminum base is designed to form a seal on most panel configurations and roof pitches regardless of pipe location.
Select the appropriate Master Flash for pipe or duct diameter. For extreme pitch or surface irregularity select next larger size.
* Other Colors Available Upon Request *
Brown, Bright Red, Dark Green, Light Green,
Dark Blue, Light Blue, White, Terra Cotta
Specifications
FLASHING DETAILS -
Top Opening Diameter - 4 3/4"
Cut to Pipe Size - 4 3/4" - 10" (121-254mm)
ADVANCED OZONE RESISTANCE - tested to 70 hours @ 500 pphm
HIGH TEMPERATURE RESISTANCE -
Intermittent - tested to +135C (+275F)
Continuous - tested to +100C (+212F)
LOW TEMPERATURE RESISTANCE - tested to -50C (-65F)
TENSILE SET (max.) - 10 MPa (1450psi)
COMPRESSION SET (max.) - 25%
Installation
SELECT & TRIM
Choose appropriate Master Flash with opening at least 20% smaller than pipe diameter. If necessary trim opening to 20% smaller than pipe diameter.
SLIDE
Slide Master Flash down over pipe. (A non-petroleum base lubricant will ease installation.)
FORM
Press Master Flash down, bending it to conform to roof profile or roof irregularities. A blunt tool will help press flashing into tight roof angles.
SEAL
Apply sealant between base and roof.
FASTEN
Use fasteners to complete sealing. For UPC installation, fastener spacing may not exceed 1-1/2" (38mm).
Reviews (0) • Write a review!
This product has no reviews yet. Write a review!