Garrdal - Retrofit Pipe Flashing, 2 Piece

Garrdal is an American made 2 piece flashing that is designed to go around roof top obstacles such as wire masts, high efficiency HVAC stacks or other circular penetrations up to 5 3/8 inches. A split boot alternative that has a single piece appearance. UV resistant with tear away ribs allowing the flashing to adjust from a 1 1/2 inch diameter to 5 3/8.

Replacing the electrical mast flashing where a one-piece boot cannot go over the wires. There are split boots available but they take longer to install, cost more and are vulnerable to failure from snow, sticks, sway and critters. A Garrdal 2 piece flashing 8 nail installation takes under a minute. Repairing a bad flashing only takes a couple minutes and the old flashing doesn't need to be removed, Garrdal can enclose it.

Rapidly increasing conversions to or new installations of mid and high efficiency furnaces are another example of where a one piece boot can't be pushed over a pipe. Non-condensing units are typically vented through the roof and have a "hood" on the concentric pipe, condensing units need to drain out the wall. Going around the pipe with a Garrdal 2 piece flashing costs less and saves time. Once again, if the existing gasket needs repair, it can be done in just a couple of minutes without removing the old boot or having to match shingles.

Features:

• Installs in less than 60 seconds
• No Clips Needed
• Perfectly seals all pipes up to 5" in diameter
• Fast and easy,8 or 9 nail installation
• Extreme temp and UV resistant TPV and Copylene won't fade
• Allows for pipe sway
• New Construction Appearance
• For use on shingle roofs 3/12 pitch and steeper.